resistor it self was fine. I was able to bend the pins so they would make contact, then the fan worked ok. This was a temporary repair because the connector will melt again. I was told that the dealer
The fan will work only at position 4 (maximum), is it the control ? its the resistor. its located down to the left of the blower motor, 4 wires.
heater fan only works on high This is caused by a defective blower motor speed control resistor, the resisitor is located next to the blower motor.
...but does work on 4/hi this is only the fan/blower. what causes this& how do I fix it? replace blower motor resistor located near blowermotor I have the same problem... how much was it to
Question about GMC Canyon
resistor pack - usually located in the heater air ducting in the blower fan airflow. Check for loose connections and open circuit resistors on the unit. If speed 4 works always, its unlikely to be the
...fan only blew on high #4 then it just stoped so I was told to replace wires And the resistor still nothing thanks Matt Do you know how to test electrical circuits ? Look at a wiring diagram an check ...
Resistor pack located close to the blower. It has a flat connector with 4 or 5 wires, and two small screws holding in the duct. It may be a crispy critter. It happens... The blower moves air across it
...resistor at full speed, so if the fan stop completely, there is a good chance the fan is blown if it is not working at full speed. Take a voltmeter and test for voltage at the fan connector with the ...
fan resistor where is it located at Located Usually On Front Of Engine Block About the Size Of A Quarter ( Black ) with One Wire Comiig outof it The resistor pack is usually located very near the ...
blower fan resistor location blower fan run full bore constantly, bought new resistor, can't find location? Its located by the blower fan intake
284 questions posted
Usually answered in minutes!
284 Questions
146 Questions
43 Questions
13 Questions
14 Questions