...position. 4. Hang an a weight (something) with 8 pounds of weight on the lever to hold it in place. 5. Center the indicator neddle in the middle of drive position. 6. Rotate the thumbwheel on the ...
...from tray and position aside. 4. remove screws from power steering resevoir, and position aside. 5.disconnect brake fluid level sensor, and if equiped brake pressure switch. 6.remove the two ...
...sound amplifier, cd changer, rear integrated control panel, sub woofer power (fuse 3 & fuse 5) and fuse position 22 (junction box fuse/relay panel battery feed), both under the hood showed ...
...the ignition to the ON position. Pause for a few seconds and return the key to the OFF position. 5. Make a further check for leaks in the fuel system. Check the next location diagram... Also, can ...
...the ignition to the ON position. Pause for a few seconds and return the key to the OFF position. 5. Make a further check for leaks in the fuel system. It should be in your owners manual. I hope ...
...pad procedure 1. Turn the ignition to the 1 (OFF/LOCK) position. 2. Close all the doors. 3. Enter 5-digit entry code 4. Press and hold the 7 ? 8. While holding the 7 ? 8 press the 3 ? 4. 5. Release ...
...# 3 Plug is 3rd Back on Pass Side of Engine LEFT SIDE is #1,#2,#3,#4, CYLINDERS and Right is #5,#6,#7,#8 SAME APPLIES FOR THE 5.4L ...
...a year ? what do i do to get the theft light to go out? Turn ignition to run not start,count to 5,turn off key. Repeat this three times. Try to start vehicle. If its starts you are done. If not ...
...it wont start u need to turn the key to the run position listen for the pump to cycle do this 4 or 5 times and it should start unless the gas thieves damaged ur fuel ...
3,327 questions posted
Usually answered in minutes!
1,825 Questions
1,627 Questions
1,696 Questions
1,161 Questions
1,048 Questions