speedometer, rpm gauges not working my speedometer, gas gauge, temp and battery gauge are not working on my 2001 Ford Ranger XLT. However, the gas gauge and oil temp gauge are still working. What ...
...t the oil and temperature gauge work on my 1988 ford ranger? We put another motor in it and now all gauges work except for the oil pressure gauge and the water temp gauge. All is connected. What now? ...
...two holes for dial mounting. There is no adjustment, calibration or maintenance required for these gauges. The instrument cluster amplifier is calibrated to the fuel gauge. The instrument cluster ...
...2 wire one. Have a different cluster if it is the gauge. Any help would be appreciated, all other gauges work properly. Thanks. Kelley. i would check the temperature sending
My 1989 Ford Ranger 2.3L 2wd has a problem in the oil pressure area. The pressure gauge at idle says normal but when accelerating it goes past Low. I replaced the pressure sending unit and it didnt ...
...down or has come off, common problem. since it is an old ranger i would ideally suggest to get ur gauges
No gauges 1990 Ford Ranger, 2.9L. The temp and fuel gauges not working, is there a voltage reducer that operates them? If so where is it located? Yes, there is a voltage regulator for the insturments
2003 Ranger Edge Fuel gauge My fuel gauge will read way over full at time and fine at other times. The check engine light will come on with the bad reading. I need help to figure this out. When the ...
fuel gauge dont work 1984 ford ranger either you have a bad gauge which you can test by grounding out the wire when grounded it should pin your gauge full you can get to the wire from on top of the ...
Question about Ford Ranger
...ford Ranger? oil gauge vibrates loudly after driving freeway speeds (65+ mph). any help? Factory gauges (especially Fords) are not known for being terribly accurate or reliable. As long as the ...
469 questions posted
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions