2003 Pontiac Sunfire "body control module location 03" Questions

Body Control Module location I have a manual for a 2004 Dakota that is probably similar to the 2006 electrically. Dodge never called it a Body Control Module; earlier models did have the Central Timer

...control are in the liftgate. The module is in the left rear quarter trim panel. SECTION 501-03: Body Closures 2003 Expedition/Navigator Workshop Manual REMOVAL AND INSTALLATION Power Liftgate Module ...

...body control module (BCM) supplies battery positive voltage to the normally open stop lamp switch. When the driver presses the brake pedal, the switch contacts close and battery positive voltage is ...

...Body Control Module, which is powered by underhood fuse block Body Control Module 2 mini-fuse 36 (15A), and underhood fuse block Body Control Module 7 mini-fuse 69 (10A). Pulling these fuses should ...

...body and pettal and is still messing up do u think it could be the ecm? everone says replace ecm computer check for an obvious loose ground at G103 located next to the right cylinder head just below ...

...body control module (BCM) controls the headlamp relay by grounding the control circuit of the headlamp. Diagnostic Aids • If the DTC B2577 is a history DTC, the fault may be intermittent. Refer to ...

...body control module (BCM) controls the park lamp relay by grounding the control circuit of the park lamp relay when the headlamp switch is turned to the PARK or the HEAD position. This energizes the ...

body, and the ECM (Engine Control Module) uses the signal generated from the MAF sensor to determine how much fuel the engine receives. However, before you replace the MAF sensor you should be certain

...body control modules (BCM).  The pins are very tiny, and there is not very much surface area for them to make good contact.  Then they tend to get this powdery substance on them that is ...

...body control module (BCM) by a signal on the headlamp switch on input circuit when the headlamp switch is in the HEAD position. When the headlamp switch is in the AUTO position, the BCM determines ...