1997 Mazda 626 "crank sensor problems" Questions

...crank it up And it fired right up. What should I do? check the connections to the battery. Sometimes this is the only problem from corrosion on the battery terminals Sounds like electrical and also a ...

...crank sensor, air filter, cats, air intake sensor and sundry other little things. It dies suddenly on the freeway. It runs perfectly otherwise. It started up after 10 minutes the first time, 2nd time ...

...crank angle sensor" may be getting to the end of its life: the fault you have described is a common symptom of this failure. The sensor is easy to replace but not cheap to purchase. hey 626 fan would ...

mazda 626 with no spark im looking at a mazda 626 with the v6 with no spark? could that be the cranks shaft sensor make that problem be for you dig to deep into something like that take off the ...

...plug wire, Lay it close to were you pulled it off of (Do not hold or touch you may get SHOCKED) and crank motor (need two people) look and listen for a spark, if you see or here a spark, then go to ...

My car got FS engine. it cranks but no spark on plugs.replaced another distributor still got same problem.supply is on connector. TESTING Disconnect the crankshaft position sensor wire harness plug. ...

...crank sensor i had this happen with an old cavalier of mine when it got hot i would have to wait for it to get cooled off before i could get it to start again i took it to a mechanic friend of mine ...

crank position sensor replaced twice but light is still on how to turn off lighr Just because you replaced a sensor doesn't mean you repaired the problem. To make sure, have the code cleared and if it

...you say everything goes dead are we talking all lights, radio, wipers? If so, main power or ground cables bad or fusible link. If just engine, check coil, ignition module, crank/cam position

is there a way to test the ecm on a 1992 mazda 626 pcm wernt a big problem for mazda check your crank position sonsor and or cam position sensor hoped i helped