2004 Chevrolet Silverado "remove air door actuator" Questions

...Remove the floor air outlet duct extension (1) from the floor duct (2). Remove the floor air outlet duct extension (1) from the floor duct (2) Disconnect the electrical connection at the blend door ...

...air until winter. Actuator is under the dash right by the blower. In addition to faulty actuator motors, the blend door itself can also be broken. This happened on my Tahoe. Typically it is a very ...

Remove the floor air outlet duct extension (1) from the floor duct (2). Fig. Remove the floor air outlet duct extension (1) from the floor duct (2) 2. Disconnect the electrical connection at the blend

...Air conditioning works well on both sides your actuatior foe the drivers blend door is stuck. try unhooking battery for a few minutes have both on heat and hook back up and start up. the actuators ...

...air out. Any suggestions are greatly appreciated. There is an actuator located at the bottom of the dash .. just remove it and turn that little shaft with a pair of pliers gently one direction or the ...

...air on both sides of truck you do not give enough info. is the temp gauge showing the engine temperature is normal, about in the middle or a little less. if it reds colder probably the ...

Remove the air inlet door motor mounting screws. CAUTION Do not attempt to bend any part of the air inlet duct door lever. Rotate and remove the air inlet door vacuum control motor. To Install: Rotate

...the blend door actuator located on the driver side of the air distribution housing. Remove the two screws that secure the blend door actuator to the actuator mounting bracket and remove the ...

...Remove the floor air outlet (center) from the vehicle. Remove the vacuum connector. Slide the actuator off the mounting bracket in order to remove the actuator. Rotate the mode door linkage ...

...Remove the floor air outlet duct extension (1) from the floor duct (2). Fig. Remove the floor air outlet duct extension (1) from the floor duct (2) Disconnect the electrical connection at the blend ...