2002 Chevrolet TrailBlazer "change brake light chevy spark" Questions

brake is pressed, note the wire color and find it where it comes to the steering column and test there... This would eliminate wires and connections between front and the rear of the vehicle, unlikely

...change the head gasket and since i did that it has been doing this any recommendations? Btw I have replaced just about everything on it... water pump, altenator, head gasket, radiator, a bunch of ...

...chevy lumina starts and dies what is the problem. Could it be the computer, the fuel pressure regulator or the map sensor. It is a 3.1 there is a purple and yellow wire that is located right side of ...

brake lines would have to be removed. I am sorry to tell you that you may have to do that. American car & truck makers regularly make mistakes, some are funny, most are closer to terrible. Example

...brake booster. Does the condition persist when you are driving? At all engine speeds? Does the condition only or primarily occur when the engine is cold? How old are your spark plug wires and plugs? ...

...change, oil treatment added and also gas system treatment has been added and the ignition burner coils have been bought but not replaced yet but one of the old ones that was taken out has oil on it. ...

...light was on i took it to auto zone had them check the codes what they pulled was P0141 (O2 sensor) P0301(cylinder misfire cylinder number one) P0140 ( O2 sensor) With that i did not want to play hit ...

change them as well as the air filter. p0300 usually means Random misfire check plugs, wires The engine control module (ECM) uses information from the crankshaft position (CKP) sensor and the camshaft

brake booster or on top of motor you should hear a hissing sound if it is.also have your egr valve checked that will couse it as well.try taking it to a parts store like autozone or o-riely's and have

...change it be sure engine has cooled down and car is in park with park brake is engaged..disconnect ground cable from battery for safety and to reset computer to clear all trouble codes if any were ...