...vortec with flat cap, style do you have flat cap or reg. dist cap ??if it is flat cap look on mounting area on dist there are 2 marks , do not line up on # 1 ther will be a 6cyl. mark or an 8 cyl. ...
...sensor on a 2006 chevy trailblazer 4.2 lL vortec? Hello rentmyhubby3, The crankshaft position sensor is on the lower left hand side (drivers side) of the engine. See image below. Regards, ...
Question about Chevrolet S 10
...vortec engines This system does not use the ignition module used on the DI systems in the past. The VCM controller now controls the ignition control (IC) and bypass functions. The crankshaft sensor, ...
location of crankshaft sensor for 2000 chevy silverado 6.0 vortec? The crankshaft position sensor is located on the top rear center of the engine near the bell housing. Hope this helps.
...on a 1999 5.3L chevy vortec engine There is no distributor. Firing is controlled by the computer which gets signals from crankshaft position sensor and camshaft position sensor for firing and
Question about Chevrolet S 10
...vortec 4.3 engine is lacking power and backfiring!!! Codes I am getting off my scan tool is camshaft and crankshaft sensor correlation error please help check the firing order for crossed HT leads . ...
...vortec runs OK cold, runs rough or dies warm - cylinder 4 misfire and crankshaft position sensor error replace the CKP and the truck will need to go to a shop and have the "crankshaft variation ...
...vortec 4.3 v6. Won't start.I've had those codes for several months, but was too busy to get it fixed, with occasional rough starting or poor idle, now it cranks fine but won't fire. P0016 Crankshaft ...
...crankshaft sensor is located as im told that is the most likely culprit. its a 4.3 vortec 4x4 slt model if that helps. Hello jerryparker6, The image below shows the location of the crank position ...
...crankshaft position sensor on 1999 gmc sierra vortec 5.3 passenger side behind the starter I three different people telling me where the crankshaft position crank angle sensor is located, but am told ...
1,155 questions posted
Usually answered in minutes!
1,473 Questions
904 Questions
747 Questions
686 Questions
620 Questions