...ignition switch and the starter relay. If you have a manual transmission, you can further isolate the short by pulling the connector off the switch above the clutch pedal. Put another fuse in and try ...
...Ignition Switch Harness Parking Light Negative Wire (-): Red/Black Parking Light Negative Wire Location: At Steering Column Harness Parking Light Positive Wire (+): Green Parking Light Positive Wire ...
Question about Nissan Pickup
...relay is activated for a few seconds when the ignition is turned on before starting the engine. If everything is working properly, you should be able to hear the fuel pump run for those few seconds ...
Question about Nissan Pickup
...ignition coil (1 for 4cy, and 1 for v6 engine, unsaid) on one car there is a IGN fuse 7.5 amps and runs the ECU and main relay. there are 3 engines, and drawing for all 3. get the fsm and use that or ...
...ignition switch, (some are $100) that 5 relay saves 100 bucks. and repeats. the relay also us for logic the USA laws mandate a park /in gear lock out so the relay did that, at blk-pink wire. now ...
...relay were good. problem was in the ignition switch , found burnt contacts in switch . i took it apart cleaned all contact's reinstalled -charging system now works and so do all instrument lights and ...
...Ignition Switch that says "To Fuse Block." The fuse block will have a fuse and/or relay for the pump and will then have a wire from the fuse box to the pump. OK? Click to Enlarge 08 2008 Nissan 350Z ...
...ignition key. If there is power, the relay is bad. If there is no power, the starter circuit is suspect. Step 4 Check to see if there is power to the neutral safety switch if there is no power at the ...
Question about Nissan Pickup
...Ignition gauge fuse and turn fuse. Terminal 1 goes to daytime rinning light relay. Terminal 3 goes to acc fuse or radio. Terminal 8 goes to another fuseable link to batt. terminal goes to starter ...
ignition control module, located, I think, on the firewall driver's side. Did you check for codes by jumping "t" and "e1" on your little diagnostic connector(same location as igniter-lift cover on
879 questions posted
Usually answered in minutes!
829 Questions
428 Questions
367 Questions
319 Questions
286 Questions