1995 Nissan Pathfinder "controls speed blower motor 95" Questions

...blower motor speed controller? It is mounted right near the blower motor itself.... attached to the blower motor via a electric cable.... held in place in it's mounting by 2 screws into the heater AC ...

...blower motor will only run on high it is 95% certain that the Blower Motor Resistor Pack has failed. The fix is to replace it. There is a 5% chance the blower motor speed control is bad but

the blower works on low speeds , then cuts out on high speed, it's the relay. Usually when controller start dieing, they will work on a couple speeds and not the rest..Or work one day and not the next

...blower motor. The electric fan motor behind the radiator is called the cooling fan motor. If the resistor block is OK, then you have either a bad fan speed switch or a melted electrical connector at ...

...blower speed. The lowest setting uses all the resistors and the setting below high speed uses on resistor. Since none of the lower speeds work either the resistor for the setting just below high is ...

...speed resistor. Usually this is the #1 cause of the blower control not working. It runs the lower 3 speeds of the blower, the highest is hooked directly to the 12v power system. Also, if you have ...

...blower works on high speed and not on the low ones these resistors go bad all the time. I dont have the information you are looking for but what i am saying is if you are having a problem with it and ...

...speed setting that portion controls goes out completely, not just slows down. Most automotive blower motors have an independent resistor coil for each speed that you can select. If one of them goes, ...

...controls the fan speed? The fact that the blower will run after you tap it suggests to me that the motor is possibly faulty.You will have to remove the fan assembly,then feed it 12 volts directly and ...

...blower motor resistor. Which resistor provides ground depends on the speed switch setting you choose. But the whole system depends on ground G01. If that ground is bad or corroded, the blower won't ...