2000 Chevrolet Blazer "remove seat belt retractor cover" Questions

Ad

Question about Chevrolet Blazer

1 Answer

...seat. Remove adjuster cover. A Slide floor anchor cover. Remove floor anchor bolt. B Remove shoulder anchor bolt. C Remove front and rear kicking plate, then remove center pillar upper and lower ...

Ad

seat heater, remove the harness band (A), and disconnect the seat subharness connector (B). If equipped without seat heater, detach the seat belt switch connector clip (C). Detach the seat belt buckle

Ad

seat belt retractor so i can release the belt? of course it possible to access this retractor , you just need to locate the small round circles in the lower part of trim and gently pry the covers off

Question about Chevrolet Blazer

1 Answer

...remove the plastic seat belt retractor covers, on the floor by the "B" Piller If you need to replace them, the retractors I mean, there is a special GM Torx Driver Bit for seat belts I would play ...

Question about Chevrolet Blazer

1 Answer

...is twisted. How do I remove the panel covering the retractor so I can straighten it out on the retractor itself? Don't remove the retractor. Remove the bolt just behind the seat and twist the ...

...remove the seat cover to the extent to reach the mechanism. This can be located at the bottom of the seat.. but more than likely is located at the shoulder area. The Seat cover (fabric) is removeable ...

...retract in Remove the plastic covers,and check out the retractors The seat belt will be replaced as a complete assy. All belts,retractors etc,and will cost you a fare amount, if it needs to be ...

...remove the seat back cover then the seat belt retractor. You can then position the seat belt retractor upright (how it sits when the seat is up) and pull the seat belt out making slack to raise the ...

Question about Chevrolet Blazer

1 Answer

...seat belt wont come out of the B-pillar?? You will have to remove the B-pillar cover to REPLACE the retractor. It is not recomended to attempt a repair on a seat belt(unless it is just twisted and ...

...remove a plastic panel from the seat (the one you can see when you open your door). Than you will see a wire in plastic cover. It connects an airbag in your seat and yellow connector under the seat. ...

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

3,415 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...