...4 door is a little easier and can be done with it flat on the ground. The 2 door had a rear tank and the bolts have a tendency to become a little more rusted. Remove the skid plate under the tank if ...
...remove the Fuel Rails which should contain 4-connected Fuel Injectors. Keep the Fuel Lines connected. Remove only 1-Fuel Rail at a time. This is where the 3/8ths in CLEAR Plastic Tubing comes in. ...
...4 with the 2.8 v6. mine do that I had to pull the gas tank replace fuel filter plus had to take undo the line from the intake and blow air thru it. Make sure all u're filter are replaced and y u have ...
...4. Remove the filter using normal hand tools on one end. The other end may be fitted with plastic clips that squeeze together to release the fuel line. (If you happen to break a clip they are ...
...4.3 liter engine? Removal & Installation Before servicing the vehicle, refer to the Precautions section. Properly relieve the fuel system pressure. Drain the fuel tank. Support the fuel tank. ...
...to remember are to use open end wrenches to loosen fuel line fittings and not to let the tank down to far before disconnecting the wires. Expect to spend 3 to 4 hours if you haven?t done this
...4 or 5 times to run the fuel pump it will start. What could cause this problem? Thanks steve Most likely fuel pressure regulator or injectors under intake plenum leaking fuel. Remove intake plenum ...
...4. Remove the throttle cable and the bracket from the upper intake manifold. 5. Remove the cruise control cable, (if equipped). 6. Remove the fuel lines from the intake to the rear of the block. 7. ...
...remove the fuel filter that is mounted to the frame along the left rear side of frame. Place a metail container under the fuel line when removing it from filter. Turn on the ignition momentarily to ...
3,418 questions posted
Usually answered in minutes!
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions
982 Questions
