front to back. Once its assembled and you have started the engine, use a timing light to fine tune timing (most chevy engines like 8degrees before top dead center, regardless of manufacturer settings)
Question about Chevrolet 1500
how do i replace left front axle seal on 1998 chevy k1500 4x4 nothing yet Remove caliper and rotor, spindle pull out axle replace seal.the reverse process.
...chevy 4x4 k1500 The front brake calipers are held on by two long bolts with female 3/8" Allen heads on them The socket needed will be a 1/2" Drive 3/8" Allen. The bolt heads are at the rear of the ...
...chevy truck 350 vortec number 1 plug wire should be pointing towards the front drivers corner . drivers side piston order is 1-3-5-7 front to back .passengers side front to back is 2-4-6-8 then the ...
...chevy 350 my kid changed wires on my truck and mest up 1988 Chevrolet K 1500 P/U 5.0 liter V-8 VIN "H" Hope helps. 1-8-4-3-6-5-7-2 is the fireing order. #1 cylinder is on left front of engine. the ...
...removing it. There are no timing marks on the front dampner to help in realigning it if you don't. Also, check the gear for abnormal wear, as mine was worn on one side, causing a strange, intermitted ...
Front Plug. Have someone Bump the Engine a Little at a Time Until You Either see pressure Rise on a Gauge or Just Put your Finger on The outside of the #1 Spark Hole ---When you feel AIR ==Compression
...wont work after replacing everything new on the truck wheel cylynders brake pads all around master cylynder brake shoes front caliper and rotors and brakes wont work at all all the way to the ...
...front brakes dont release all the way causing my rotors to heat up. I changed calipers, brake hoses, master cylinder, brakes and they still wont release need to change master cylinder and blld ...
1,299 questions posted
Usually answered in minutes!
795 Questions
754 Questions
575 Questions
561 Questions
414 Questions