Question about Chevrolet Suburban
need head bolt, intake manifold, and exhaust torque specs need head bolt, intake manifold, and exhaust manifold torque specs for 1993 suburban 350 efi, Thank you! Cylinder Head Bolt Step1- (25 FT.Lbs)
need manifold gasket ...
how do i change an intake manifold gasket in very easy terms it is for a 1990 Chevy suburban Scottsdale? You unbolt the intake manifold, remove the old gasket, install a new gasket, and bolt the ...
where would a map sensor be located? on 1999 gmc suburban Hi, the manifold absolute pressure (M.A.P) sensor is located on the intake manifold. I am not familiar with the GMC vehicles as I am in South ...
had manifold line leak and compressor shaft seal leak. 1999 suburban with rear air. replaced manifold line, acumulator, and compressor. rear air does not get cold unless you raise engine rpm's for
...can cause by a lot of components. Dirty air filter Dirty injectors + o-rings Vacuum leak at intake manifold and vacuum hose. Bad Idle Air Control Motor (IAC) Low compression (170 psi + is OK) Start ...
...can cause by a lot of components. Dirty air filter Dirty injectors + o-rings Vacuum leak at intake manifold and vacuum hose. Bad Idle Air Control Motor (IAC) Low compression (170 psi + is OK) Start ...
...miss. check to see if a spark plug has come loose and letting compression escape Maybe check the manifold bolts, or the exhaust manifold
...you're facing the engine its the biggest hose on your left going from the radiator to the intake manifold undo the hose clamp on the hose connected the intake manifold pull the hose off, undo the
will also need a torq wrench in inch pounds. Take your time, keep it clean. Make sure you clean the manifold and engine head surfaces where the gasket seats. Use a non metallic scraper, and if need be
715 questions posted
Usually answered in minutes!
550 Questions
461 Questions
355 Questions
338 Questions
292 Questions