1994 Chevrolet Camaro "check start condition set" Questions

Ad

Question about Chevrolet Camaro

3 Answers

start but I can only go 2 blocks if I try to do a burnout it will shut down& it's not the fuel pump it could be a wiring problem in the circuit or the injectors have a resistance problem or maybe even

Ad

...set. Perform the Powertrain On-Board Diagnostic System Check first, when the following conditions are present: • When the MIL does not turn ON when the the ignition switch is turned to the RUN ...

Ad

...check engine light indicates active engine misfire. There should be codes set for these conditions. It could be low fuel pressure, but if you have not replaced the spark plugs and wires, I would look ...

Question about Chevrolet Camaro

1 Answer

...start the engine. Check the pressure gauge. It needs to register between 45 and 48 psi. Start the engine and let it idle. Check the gauge again. It needs to register approximately 46 psi. Leave the ...

Question about Chevrolet Camaro

3 Answers

check the coolant level in the reservoir bottle before you open and bleed each valve and top it off with fresh coolant as needed. If the reservoir bottle is allowed to empty it will **** more air into

check the coolant level in the reservoir bottle before you open and bleed each valve and top it off with fresh coolant as needed. If the reservoir bottle is allowed to empty it will **** more air into

...start and immediately stall if the condition that set DTC P1626 occurred before the PCM received a valid theft deterrent password. With this condition present, the PCM will inhibit fuel delivery and ...

...check engine' light on though but does have a P1599 history code stored in it. I'm just not sure of the exact location of the crank sensor. DTC P1599 Engine Stall or Near Stall Detected ...

...mounts for condition . Check steering insert condition and top mount rubbers and bearings if McPherson strut set up.. If you have a steering shock absorber then check it's condition and ...

...a check engine light, The vehicle has to see a drive condition before it set,its usually a two trip condition meaning a cold start at 60 F to operating temperature of 160F. twice. And being

Not finding what you are looking for?
1994 Chevrolet Camaro Logo

783 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29492 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...