...rear wheel speed sensor is part of the hub/bearing assembly. Refer to Wheel Hub and Bearing Replacement in Rear Suspension for service procedures. I hope help you with this (remember rated this help) ...
...rear wheel speed sensor is part of the hub/bearing assembly. Refer to Wheel Hub and Bearing Replacement in Rear Suspension for service procedures. I hope help you with this (remember rated this help) ...
...rear with new pads and rotors most likely you have a bad wheel speed sensor or a broken wire to the wheel speed sensor. you will need it scanned to find out which sensor is acting up. if it is a ...
...wheel sensor thus need the hub bearing changed since sensor is built in. If it's the brake light then there is a pressure problem like a small leak in lines or even the rear brake cylinders or front ...
...wheel speed sensors, or the electrical connections to these sensors. The front seem more problem-prone than the rear. As 'first-aid', the preliminary step usually involves removing the wheels and ...
...wheel speed sensor, while some one drives the car for you, check MPH on front and rear wheels sensor, the one that show 0 MPH is the bad sensor. Replace and recheck, Also check harnness first. There ...
...wheel speed sensors, or the electrical connections to these sensors. The front seem more problem-prone than the rear. As 'first-aid', the preliminary step usually involves removing the wheels and ...
...i always had good brakes, i just happened to be under the car replacing the mufflers and noticed a very small wet spot on one of the rear lines so i replaced the line and noticed all light went
wheel hub) a small bolt secures it to the hub, remove the bolt and move the sensor to the side out of your way. 11) locate and remove the three hub retaining bolts (reachable from the rear of the hub)
2,566 questions posted
Usually answered in minutes!
1,538 Questions
1,504 Questions
1,435 Questions
1,208 Questions
1,285 Questions