1997 Pontiac Grand Prix "replace exhaust manifold studs motor" Questions

...exhaust manifold? I am replacing the motor. Thank You exhaust to cylinder head nuts 11 ft lbs exhaust to cylinder head studs 97 in lbs flywheel 22 ft lbs Please rate this a fixya if this answers your ...

replace exhaust manifold How do I remove and install exhaust manifold including torque specs. which engine.? 8v or 16v. the manifold unbolts, see the studs there. they are nuts acutally the trail pipe

...exhaust manifold and move the tube bracket away from the starter. Remove the electrical connections from the starter. Remove the bolts attaching the starter to the flywheel housing and the rear ...

...exhaust manifold. i know the valve cover gaskets needs replaced but i cant see where the leak is coming from, so i was wondering if it would be the head gasket or the freeze plugs. there is no anti ...

...REPLACE IT.. REMOVAL & INSTALLATION 2.0L SOHC Engine With Automatic Transaxle; 2.4L Engine Disconnect the negative battery cable from the left strut tower. The ground cable is equipped with a ...

...exhaust manifold where the r exhaust comes to the motor my exhaust looks like it just popped out of where it comes to the top of my motor. i think it was called a few days before when i hit a kerb at ...

...replace the O-ring. If removed, position the oil pickup tube on the oil pump and hand start the 2 bolts. Install the bolt retaining the pickup tube to the main bearing stud spacer hand tight. Tighten ...

...replace the O-ring seal on the thermostat housing. Position the housing and upper hose and install 2 retaining bolts. Torque to 15-22 ft. lbs. (20-30 Nm). Reconnect the heater water hose. Reconnect ...

...exhaust gases that sounds like ticking. I'll also bet it's louder when the motor is cold. My research indicates that just about every motor like this experiences this issue. Design flaw allows H2O to ...

...exhaust manifold flange bolts. even after soaking them with nut buster they usually snap. if your not going to reuse them like me no big deal. otherwise heat them with a torch take out the broken ...