...combination of any of the before mentioned....hope this helps, Your Engine has a upper and lower intakes the 3100(3.1L) and the 3400(3.4L) engines both had lower intake gasket problems.Coolant runs ...
Question about Cars & Trucks
...pulled a rubber band that had found its way into the fuel line. If the line is old and has a small crack, then air can be sucked into the line on the vacuum side of the pump. I have also seen that a ...
...combination wrenches, 10mm, 12mm, 14mm (3/8ths drive) sockets, 6 inch (3/8ths drive) extension and a (3/8ths drive) ratchet. It's 1:oo Am and I'm not at my shop, so I can't go and look at a car to ...
...source of the master cylinder?. if it has a leak then it wont work properly. check the hose from cracks and chippings. check where it is connected and check if you have a good source of vacuum
...residual pressure, as well as fuel that can spill out when it is removed. Eliminate pressure by cracking a fuel line loose near the engine or depressing the Schraeder valve on the fuel rail. Gas ...
...right hand bracket, you will need to connect a jumper wire between the brackets. If one washer is cracked or missing, it is likely they all are. b. Disconnect the horn wire from the left hand ...
...Combination Wrench set ($20) from Sears which has a 7/32 closed end offset wrench. Without it, I could not come close to getting that top screw. Even then, it was tough. Totally by feel to get that ...
...locks in the cooling system, head gaskets/cracked heads problems, low water level in the radiator, faulty viscous fan hub ( if fitted to fan), problem in the ecm control of the vehicle, Running too ...
2,035 questions posted
Usually answered in minutes!
1,771 Questions
1,504 Questions
1,435 Questions
1,208 Questions
1,285 Questions