2003 Chevrolet S-10 "cylinder misfire" Questions

...cylinder misfire-- can't clear- so I change # 3 spark plug to # 1 and I get the # 1 plug code that will show the P0301, change plugs , and now I get a p0300 code = a Random misfire!!!!! can any one ...

cylinder 2 misfire on a 1998 chevy blazer I have a cylinder 2 misfire on my 1998 chevy blazer and have already changed the plugs check your plug wires for tears and dont overlap them

...reporting P0342 until camsensor was replaced. Now no codes, reports misfire on Cylinder#1 or random misfire. I had to rebuild my engine at 97000 miles cuz of low engine oil pressure and bad ...

...misfire in cylinder #1 I have a 2002 s-10 2.2l with 60,000 miles. I changed the plugs and wires and it still tells me there is a misfire in cylinder #1. The truck also been running a little rough due ...

...cylinder 3 misfire, Where do I start looking for solutions? get u a heat gun and check ur temp on the exhaust manifold while truck is running bellow each plug the one misfiring will be considerably ...

...misfire. If the last digit is a number other than zero, it corresponds to the cylinder number that is misfiring. A P0302 code, for example, would tell you cylinder number two is misfiring. ...

plugs out, check the gap, and when you reinstall them  after the compression test, swap it with another cylinder and see if the misfire follows the plug. You may want to do the same with the wire

...misfiring, and loses power: reads codes cylinder 3 misfire, O2 sensor, crankshaft position sensor, and camshaft position sensor it sounds like you need to re time the motor .the belt must of

spontanious misfiring on a chevy s-10 pickup 2.2 motor. The truck starts and runs but misfires on different cylinders and at different times. go to auto zone get codes what year? distributor, tune up,

...code P0300 on a 2002 S10 truck 4.3 v6 random misfire what you have is a random multiple cylinder misfire, most likely cause is the ignition module, other cause can be bad or worn plugs and