2000 Chevrolet Prizm "stalls put reverse drive" Questions

put it in drive or reverser it wont run If you have a check engine light on than look for the code and see what it is. Ckeck the camshaft senser too. And fuel pressure to see how much you have complex

...put it into reverse and then drive it will die and I have to restart it. Is that a sign of the transmission going out or what??? Usually when a transmission is going out, it will be slipping, not ...

put into drive the car shakes and stalls. It 1992 mazda protege. When put into drive the car shakes and stalls. It starts right up and runs smooth in park. Also, it runs and does not stall or shake in

...stalls when I put it in gear - even after it runs for 20 min. Sometimes it will stall while I'm driving. I had carborator replaced last year. Hope you can help. Some possible causes could be: Vacuum ...

...put in,mechanic said would fix stalling in drive,didn't.Still stalls.Couldn't fix issue in reverse.Any ideas? Usually the problem is due to a dirty throttle body or a faulty idle air ...

...stalls when put in either drive or reverse on '96 caravan. I was told it was most likely the transmission solenoid. Any other causes? Engine stalls when put in either drive or reverse on '96 caravan. ...

...stalls went put in drive but runs great in reverse when i put it in drive it stalls and when i give it a little bit of gas it stalls but runs great in reverse The fastest way to check for the problem ...

...stalls,if i put it drive without the brake it ok,if i step on the brake it stalls;what do you think? Sounds like your vacuum assist brakes diaghram has sprung a leak. Pull the hose to the assist and ...

...put it in drive or reverse it stalls out everytime. when i roll the durango then put it in drive it will go and shift great but when i slow down to almost a stop it stalls. it only stalls when iam ...

put it into drive (reverse works though). If I stall in drive, put it in neutral and then back into drive AND START IT BACK UP IN DRIVE it won't stall. Any thoughts? Check your crank shaft sensor. You