1998 Oldsmobile 88 "fuel filter" Questions

...fuel filter on 1999 olds 88 with v6 Locate the fuel filter. One side will unscrew using a 16mm open end wrench on the pipe, and hold the fuel filter with a 20mm wrench, and unscrew. The other side of ...

...fuel filter, where is the location of the fuel filter? Along the frame rail under the car you should see the fuel lines on the driver side. Along the line around the front driver door area there ...

...fuel filter and it was wet. i replaced that and then found there are (2) steel lines next to the fuel filter and one of them is leaking. can you tell me what it is and how to replace it? The other ...

...fuel filter. A dirty fuel filter will restrict your fuel flow and will give you what you have described. Here is a link for you to retrieve any DTC codes that may causing your engine's issues, but a ...

fuel filter fuel pump battery ntake manifold plugs wires coils O2sen throttle body vacuum lines/fittings Starts right up. MissesBackfires as I take off. From 0-55mph runs better still backfires. Right

...88 royale and fuel filter location pump: is in the tank. filter: check underneath the car's driver side just in front of the rear wheel. fuel relay: Under dash on the right side above the kick

gotten dirty from changing the fuel pump and filter. Also check for water in the fuel system. It may not be fuel related at all.check plugs ,coils ,wires to see if they need replacing. Hope this helps

...FUEL FILTER UNDER THE CAR NEXT TO GAS TANK.NOT HARD TO CHANGE BUT.YOU NEED.ADJUSTABLE WRENCH / IN LINE WRENCHES / AND NEEDLE NOSE PLIERS AND A REPAIR MANUAL.TO SHOW YOU THE PROCEDURES OF REMOVING THE ...

fuel filter, if so where are filters located?? it sounds as if your fuel pump is bad. depending on how many miles you have on the car, the fuel filter may be clogged. this is usually located along the

...fuel filter Fuel filter is located in front of the fuel tank. Locate it, unscrew the outlet line with a line wrench. Firmly press the tab on quick release fitting to disconnect the inlet line. Now ...