1997 Oldsmobile 88 "getting oil sending unit" Questions

Ad

...oil pressure sending unit.. The best way to tell if the relay is bad is how long it takes to start cold .If it fires up quick then the relay is good and the problem is likely with the oil pressure ...

Ad

...unit and dripping on the floor inside the passenger compartment. Look for stains or wet spots on the bottom of the plastic HVAC case, or on the passenger side floor. Intake Manifold gasket -- The ...

Ad

oil sending unite on 1995 couger IF OIL SENDING UNIT LEAKING OIL NEED REPLACING.WHEN INSTALLING NEW OIL SENDING UNIT.YOU CAN USE TEFLON PLUMBERS TAPE ON OIL SENDING UNIT THREADS BESURE WHEN INSTALLING

Question about Oldsmobile 88

1 Answer

...oil pump and sending unit but still no oil pressure but engine does not rattle or knock when running The sending unit is a variable resistor. When the oil pressure is normal only a small amount of ...

oil pressure sending unit? where is the oil pressure sending unit on a 1996 GMC 4WD Suburban? The oil pressure sending unit is located on the engine block, passenger side by the Distributor. Good luck

...oil sending unit be bad or the oil pump there are no oil leaks anywhere but i think thermostat is bad this started after the engine over heated i am going to replace the thermostat do you think that ...

Question about Oldsmobile 88

2 Answers

...oil sending unit if you have access to a direct reading oil pressure gauge put it on and if oil pressure is reading normal replace sender Common problem with the sending unit on the LT1, pegs the oil ...

Question about Oldsmobile 88

1 Answer

...oil sending unit or get a manual oil pressure gauge and screw in to oil sending unit port and visually check with engine running to see if or what the actual pressure is. If 0 pressure registers then ...

getting oil pressure on gauge or to my valves Well, the sending unit should be near the oil filter.But I'm sorry to say if you don't think the valves are getting oil pressure the gauge and the

...oil pressure gauge in the truck will run at 80 psi all the time. Since you have a light the sending unit just says it isn't getting pressure which turns a light on. So be safe and do as i suggest, if ...

Not finding what you are looking for?
Cars & Trucks Logo

320 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...