1991 Oldsmobile Ninety Eight Regency "91 olds firing" Questions

...91 Olds 88. Replaced crank shaft position sensor, coil, and ignition module. That solved the problem. I think the culprit was the CSP Sensor, but changed all three so can't say for sure. the problem ...

91 Olds 98 Regency elite once in a while the car doesn't start. The starter fires but the engine doesn't turn on. If i wait 10 minutes or so, it starts. Based on the information you have given to this

91 4 runner immobiliser with an equator immobiliser I have a toyota4 runner which has an equator immobiliser now she won't fire have spark and fuel but won't start 91 4 runner immobiliser with an ...

my 91 f-350 diesel Not getting fuel I have a 91 f-350 diesel and when I start it it fires right off, then dies after 4 or 5 seconds. Then I have to crank and crank on it 2 get it going again have you ...

...91 ninety eight olds will not start or even fire? I have changed the control module and crank sensor but will not fire. will try to turn over but will not fire to start. MANY possibilities! Assuming ...

...just put in a different motor, and had a problem with the computer, so i installed one from a 91 wrangler, and it runs fine for awhile and after 10 mins of driving it around it will stall and ...

Need a spark plug wire diagram for a 91 olds custom cruiser 1-8-4-3-6-5-7-2 is firing order the distributor cap is marked with number one then go clockwise

91 325ix has no fire to sparkplugs Crankshaft position sensor in back of motor close to the oil pan. Careful it breaks easily if it's old.

91 olds cutlass 2.3 having problem with gas mixing with the oil......... the 2 outside plugs are dry and the 2 middle plugs are wet with gas The wet plugs are not firing. The engine must be running ...

replaced ECM,fuel pump and fuel filter. my 91 geo tracker still will not start. it did back fire out the air cleaner' it does not have a carb. this sounds like timing to me. I will start looking into ...