1998 Mercedes-Benz C-Class "remove blower motor resistor 98" Questions

...blower motor switch resistor connector. Remove the heater blower motor switch resistor (18591). Remove the two screws. Remove the heater blower motor switch

remove the blower motor.Be very careful not to damage the blower wheel.Take the wire connector off ,then remove the 2 screws holding the resistor to the blower or evaporator casing to the right of the

blower motor resistor location blower motor works only on high speed. have replaced blower motor but no change. I need to locate the resistor look under the passenger side of the dash. There will be a

...Remove the 2 screws and pull the resistor up.If your blower motor is not working.Before you replace the resistor try tapping on the blower motor while the system is on.If it comes on then the blower ...

...REMOVE LOWER RIGHT DASH INSULATOR PANEL FROM BELOW THE GLOVE BOX.YOU HAVE TO SLIDE BCM MODULE ASIDE THE BLOWER MOTOR RESISTOR ON THE BLOWER MOTOR HOUSING WHERE ELECTRICAL CONNECT TO BLOWER MOTOR. TO ...

...blower motor. All others work fine. This is a common tsb for these vehicles, it is called the blower motor resistor that has failed.This part is located on the evaporator housing .This is a simple ...

...Remove the blower motor power cable located on the forward side of the blower near the firewall. Not necessary on some models. 4. Remove the jumper cable link to the blower motor resistor located on ...

...blower motor resistor and now it works on all speeds but the resistor starts to smoke on the two slower speeds the two faster speeds seem fine. Why does it do that and what can I do? The blower motor ...

...blower box,with multi wires on a plug-in.Unplug it and remove screws,and pull straight out.The resister is your speeds for the blower motor,and the motor draws to many amps,witch in turns,burns the ...

...blower motor. If you have both present, then you need to remove the climate control head and inspect the connector for loose pins or damage. If there is nothing obvious, respond to this answer and I ...