...screw driver into the clamp so as to wedge it open and free it from the battery. Trying to pry the clamp up off the post could easily damage the battery. The least amount of force applied to the ...
...it .. unplug battery then remove connector at ECM on old ecm remove two screw and the plate remove both memory and install them in the new ECM....plug 3 connectors and battery cable hope it ...
...insulator. Blower motor cooling hose. Blower motor electrical connectors. Blower motor mounting screws. Blower
...instructions: 1. disconnect neg- battery cable, 2. then remove lower interior covers 7mm screws or 9/32. 3. locate cable for shift indictor remove with small pick. 4. locate two 15mm bolts ...
...cable at the battery. Remove the left side dashboard trim panels. Remove the cluster retaining screws. Disconnect the speedometer cable. Pull the cluster out, disconnect the wiring and remove it ...
...wipe up any coolant that drips from these hoses. Drain the coolant from inside the heater core.4Unscrew and remove the lower instrument panel sound insulator from below the dashboard on the ...
Question about Buick Century
...negative First wait 3-5 minutes Then on the back side of steering wheel is are the retaining screws that hold the air bag to the steering wheel once removed disconnect wires and place pad side ...
...high beam, other is for the low beam. The ground wire sometimes is a short wire run to a connector screwed into the body creating the ground connection. Commonly on GM cars the black is the ground, ...
...15 minutes to replace BUT make sure to disconnect the negative cable to battery before you remove it. then after it's replaced,reconnect before you re-start your car. thank you for choosing ...
455 questions posted
Usually answered in minutes!
921 Questions
813 Questions
785 Questions
797 Questions
687 Questions