...secondary air pump code but was told that would not cause problem? help sounds like the solenoid is sticking on your starter. replace the starter and it should fix it. hope this helps It's when the ...
replace the air pump, you will also need to install a updated hose assembly with a new filter. also in allot of cases the air pump fuse will blow when the air pump goes bad. the fuse is located by the
...secondary air injection system. Cause Water may have collected in the AIR pump or the vent solenoid and frozen or corroded the pump. Correction Replace the AIR pump and install a new inlet hose and ...
...secondary air pump has failed and will need to replaced. The pump is an emissions component meant to help with cold start emissions. Replace it, clear the code & you should be fine. I hope this ...
check engine light on pulled code po410 secondary air injection what do thay mean and how do I fix it? this is caused by a defective seconday air injection pump, replace the pump.
...Secondary Air Injection System"? This is not to be found in the Hanes repair book. 2. What is the "rear bumper towing capacity"? I have a 2000 2.2L Sonoma that I had to replace the motor in with a 99 ...
secondary air injection sytem. where is this located If you have a "Air pump installed on your TB then you need to replace pump and or check to make sure that the hose's are all connect to it prior to
...secondary Air Injection system, this is basically an inspect and replace broken hose detail. Leave the inlet hose disconnected and start the engine. Listen and feel for exhaust hissing at the check ...
...secondary air injection system. Cause Water may have collected in the AIR pump or the vent solenoid and frozen or corroded the pump. Correction Replace the AIR pump and install a new inlet hose and ...
597 questions posted
Usually answered in minutes!
988 Questions
829 Questions
835 Questions
322 Questions
