Question about Oldsmobile Cutlass Supreme
...rear brake caliper on a 1995 oldsmobile cutlass supreme so I can replace the disk and install new brake pads? undo the small bolts holding the brake pad housing remove pads .undo the larger 2bolts ...
Question about Oldsmobile Cutlass Supreme
;o) C- clamp works in the front. Special tool sometimes needed for the rear. 40.00 bucks To compress the rear caliper you need to turn the piston very slowly so that it will screw onto the park brake
...rear brakes start to stick. ive all ready replaced the rotors calapers and pads once. can i disable the abs? Yes i wouldnt do that it would be really dangerous your brakes hardware needs to be ...
Question about Oldsmobile Cutlass Supreme
rear this past summer. I did what you did and tried the c-clamp and it didn't work. I then read up on it and you have to turn the piston. I did this with some needle-nosed pliers and put them into the
rear brakes, what parts do i need Brake Pads for sure. Usually need to disassemble to see if drums need to be turned or if calipers are stuck or leaking. Also, a spring kit would be useful
rear brake pads? does the cylinder screw in? do you turn it counter clockwise? Yes they screw in. You need a tool to do this. Most parts stores have them. It looks like a 1 inch square with small pins
...rear disc brake pads, why? open the blled valve and try to compress, if it does not compress make sure your emergency barke is not on, if it's not on then compress calipers if it won't compress you ...
Question about Oldsmobile Cutlass Supreme
replace the brake pads on it without a spanner tool by removing the bolt that holds the pad carrier to the caliper towards the rear of the vehicle, (the other one is a post) lifting the caliper up and
...rear brakes keep messing up on 1995 olds cutlass have replaced pads 3 times as to the other ones abs light stays on all the time Could be defective caliper not releasing properly. Have seen few ...
...rear calipers? Raise and safely support the vehicle. Matchmark the relationship of the wheel to the axle flange. Remove the wheel and tire assembly. Reinstall two lug nuts to retain the rotor. If the ...
919 questions posted
Usually answered in minutes!
571 Questions
488 Questions
387 Questions
236 Questions
203 Questions