...test for spark I only have spark on cylinder 3 and 4. I have replaced the crank position sensor, alternator, and have tested with another coil. Can I remove the icu and take it to a dealer to get ...
...crank I checked battery its good.I jumped starter it turns the motor over just fine .turned the ignition to the on position does'nt start .I tested the ignition switch getting power in an out. any ...
...crank position sensor as death raider suggested but it still shuts of when it warms up help please I had this happen to me with my 91 Cavalier and it was the ignition control module. Autozone will ...
...test yet. I would assume it's not a spark problem since it starts on fluid. I'm thinking maybe pressure regulator. Not sure where to go next after that. It has a new pump and filter on it as ...
...crank and cam position sensor replacement: http://www.stealth316.com/2-cas-91-92.htm And here is one for timing: http://www.stealth316.com/2-ignition-timing.htm It is just like any distributor timing ...
Question about Dodge Cars & Trucks
...crank position sensor )so that indicates that the spark timing is generated in the pick up in the distributor body amplified by the coil and then distributed out to the plugs no spark at the plugs ...
Question about Oldsmobile Cutlass Ciera
...crank the engine over as I pushed the test valve on the fuel rail and it shot out. But all it does is crank. I even tried starting fluid and still nothing. could it be the cam sensor? throttle ...
Question about Oldsmobile Cutlass Ciera
Position Sensors. With a Digital Volt Ohm Meter (DVOM), test the 5V power supply circuit going to each sensor to insure it is being powered up (Red lead to the 5V power supply circuit, black lead to a
...crank case with oil. What s going on? You have spend a lot of money on parts, have you invested in a Compression Tester or I believe you have Blown your Head Gasket, Cracked your Head. You are now ...
It will condition the fuel pump and injectors. Try this first, Then redo the ODBII test. Erase all stored faults after reading. Put a dab of RTV on the bare wires at the crank sensor to insulate wires
479 questions posted
Usually answered in minutes!
575 Questions
540 Questions
492 Questions
476 Questions
412 Questions