...clamp you can put the caliper in its mounted position and gently pry between the caliper piston and the rotor to push the piston back. If you got a tube of blue stuff, that goes between the pads and ...
...working on.take out the two bolts that hold the calaper on and bump it off with a hammer.depress the caliper with a 6in c clamp and put new pads in and put back together.go to other side same
clamp to push in the caliper then put everything back to gether, now my pedel goes to the floor what could it be pump the pedal until it goes hard this is common when you push it back all the way just
...[USE ONLY WATER TO FLUSH OUT ] BE CAREFUL NOT TO BURN YOURSELF WITH THE HOT WATER , PUT A RAG OVER THE TEE WHEN DISCONNECTING THE LAST TURNS ON THE CLAMP.Also change out the thermostat under the
clamp off the radiator hose before unhooking it, so it doesn't leak anywhere. Then remove the hose, take the thermostat cover off, and dry everything off. Put the new thermostat in just as the old one
...its a fairly strong leak/stream the over-the-counter stop leak products will not work...tg Usually putting on a new hose that
power steering completely out The small hose behind the right wheel leaked. I replaced it and put additional clamps on it and it still leaked. My wife kept driving it and was good about putting fluid ...
and replace.Put back togather and close the bleeder vavle and take the clamp off the break line.Now you are ready to bleed the breaks.The same way for all four.{if your car has disk breaks in the back
Question about Chevrolet Impala
...clamp that holds the core and replace it. Then just go in reverse and put the car back together. Use caution when pouring the antifreeze back in, don't pour it in fast or you will get an airlock and ...
1,832 questions posted
Usually answered in minutes!
2,177 Questions
1,746 Questions
1,386 Questions
1,400 Questions
1,452 Questions