1991 Buick Regal "ignition coil connector" Questions

Ad

...the ignition control module is on a 91 buick regal? The ignition control module is usually located Under the coil packs when you remove the coil packs the ICm will have 2 male connectors for each ...

Ad

Question about Buick Regal

1 Answer

...ignition coil. Often an ignition sytem thas two wires connected to the run terminal of the ignition switch. On is connected to the module. The other is connected to the primary resistor and coil. The ...

Ad

2000 buick regal 3.8 by misfire in cylinder 5 check engine lights on Start by testing plug - ignition coil - wiring -connector- injector-if all are good then need to start checking valve train

Question about Buick Regal

2 Answers

...connector to run jumper from grd A to powr B . theres no B pin. obd1 block only has 3 pins. this is a 95 buick regal 3.8l , OBD1 or OBD1.5 . engine sputters and coughs. the check engin light comes on ...

Question about Buick Regal

1 Answer

...Ignition lock cylinder removal WARNING On vehicles with air bags, disable the SIR system. The vehicles wheels must be in the straight ahead position and the key must be in the LOCK position when ...

...ignition switch module car runs but after 20 miles sputteres and pops like its out of time. car will start after several tries fuel pressure is 40 psi Now I can manuely run the fuel pump in no start ...

...Ignition Coil Removal & Installation 4.2L Engine 1997-2000 To Remove: Before servicing the vehicle refer to the precautions at the beginning of this section. Remove or disconnect the following: The ...

Question about Buick Regal

1 Answer

ignition coil fasteners To Install: Install or connect the following: Ignition coil fasteners Torque to: 105 inch lbs. (12 Nm) The electrical connector Ignition Wire I.D. The spark plug cables to coil

Ignition Coil Removal & Installation 4.2L Engine To Remove: Before servicing the vehicle refer to the precautions at the beginning of this section. Remove or disconnect the following: The ignition

ignition coil in my 2002 ford taurus Removal & Installation 3.0L (VIN S) Engine Disconnect the negative battery cable. Unplug the engine control sensor wiring connectors from the ignition coil and

Not finding what you are looking for?
1991 Buick Regal Logo

326 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Buick Regal
1999 Buick Regal

757 Questions

1995 Buick Regal
1995 Buick Regal

631 Questions

1998 Buick Regal
1998 Buick Regal

489 Questions

2000 Buick Regal
2000 Buick Regal

420 Questions

2001 Buick Regal
2001 Buick Regal

426 Questions

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...