1991 Buick Regal "changing cam sensor 6" Questions

...Sensor. No change. Put in 6 new spark plugs w/ new wires. No change. Checked fuel pressure, exactly 40psi with key turned to "on" position. I then cut the exhaust pipe in front of the ...

...cam sensor was out. After changing that it ran beautifully. The funny part is this car was an 90 Buick Lesabre, (still the same engine, 3.8) and the owners bought it NEW and haven't ever serviced it ...

...coil packs, Changed plugs, Changed cam angle sensor Up to changing crank angle sensor and then ECU/BCM If anyone has any ideas or suggestions, please let me know. could be petrol out water in ...

cam sensor unplugged because the ecm sees the camshafts aren't in time with the crankshaft. With the cam sensor unplugged it doesn't know its out of time and it starts.' Does it means that

cam sensor, plugs crank sensor but still have week spark on no.6 tried switchin wires thinkin mabye one was bad (seen that before) but that wire and even plug would hit on other cyl....changed cap for

...how is it reached? Located near the crankshaft pulley usually. kia 2002 v6 2.7 no spark on no.1 and no4  have spark on 2&5 -3&6 have changed cam sensor no help  hope u can help tks ...

... automatic 2 wheel drive. Will start back up.Cam shaft sensor, crank shaft sensor, fuel pump have been replaced. did you change the fuel filter, very common problem that gets over looked too many ...

...cam sensors the car runs great no wench light. At 150 miles and 3 days,so far with no problems.It took me about 6 months to get it right. And I don't want anyone to go through what I did. I hope This ...

...changing the fly wheel and i was wondering the setiings to line up the sensor on the back of the fly wheel. with no1 at TDC mark is on balancer and can take off top cam belt cover to check that cam ...

...cam sensor code so I replaced the right cam censor. Problem continued and now the car will not start at all, any suggestions? sounds like your fuel pump is dying. Change the distributor. The igniter ...