Question about Chevrolet Malibu
...belt. Went through 2 belts (warranty part but my labor) on a older malibu before figuring out leak in surge tank. Silicone grease (not lithium or mineral base) was only thing that would keep it quiet ...
...belt 2004 malibu Get a 1/2" breaker bar and remove tension on belt by rotating the tensioner until belt is loose. Remove belt noting the under over method. Install new belt. The smooth pulleys have ...
...belt replacement insert a 1/2" rachet into the tension pully, pull clock wise this will relive the tension on the belt thus allowing you to remove the belt repet to install new belt. make sure the ...
Question about Chevrolet Malibu
...belt.Fig. 2.Removal and installation of the drive belt - tool is shown installed on the tensioner. Arrow points to the power steering pump pulley. To install: (1) ...
...after about 2 days, I replaced it again (thinking the belt might be bad) making sure it's on all the pulley's and IT happened again, could a pulley be bad or out of round? you have a bad belt ...
Question about Chevrolet Malibu
...belt. Alt light is now off but battery light stays on and drains battery in about 2 days. Batt probly not chargn cause main wire in back of alt is wornout. Alternator tho sounds bad..it will drain a ...
Question about Chevrolet Malibu
belt on again, fired it up and it slipped off again. so i got looking and noticed the crank pulley stuck out about 1/2 inch further than all the rest of the pulleys. how does ametal part just start to
...seat belt fire off and they can only be replaced, but insurance should cover that expense. if this answered your question please give a thumbs up to help others. theres no way 2 disconnect the ...
...belt. Remove crank bnolt if it has one. Use 1/2 impact wrench for this operation. Fit harmonic balancer puller and pull off. If no bolt ,fit puller and pull off. It will be keyed so installing new ...
2) If the belt is wearing on either side, I would suspect an alignment problem. Check mounting brackets or loose bolts.3) If the back of the belt is wearing, the culprit is a device driven by the back
1,923 questions posted
Usually answered in minutes!
1,306 Questions
1,094 Questions
1,067 Questions
997 Questions
1,026 Questions
