2004 Volkswagen Passat "vw 1 acceleration problems" Questions

...vw passat is going out on me - tying to save its life - need to replace housing unit for new air filter - fuel pump fuel filter - will that solve the problem of... 1. every single time i put gas i ...

1. ignition coils are on their last legs and would need replacing (there are 4 of them in a VW golf) 2. The throttle housing is knackered and needs replacing as it has caused the motor that powers the

...vw passat tdi 2005 has it been pressure tested? do u have any coolant stains uinder the car maybe from the water pump area? check for leaks, run pressure test HI. This issue has many causes. i will ...

...VW again. were is temp gauge at? should be in the middle of gauge if not RR stat.make sure the cabin filter is good or youll get no air flow 2001 1.8 passat here what i did with drove car till warm ...

...VW Passat GLX VR6 2.8L my MIL came on today ran a OBD2 came up P0411 (Secondary Air Injection System Incorrect Flow Detected) and P0172 (System Too Rich bank 1 sensor 1) i then followed up with a ...

...VW Passat 6 Speed Automatic I am havinf hesitations/delay froma dtopped postion for around 3 seconds when you press the accelerator ? Poblems I know. Suggestiobs ? The engine is a 1.8 Liter TSI 16 ...

...vw golf when i try and take off or accelerate it is very slow and has a hard time with up hill 1)reset the ignition timing for specification from manufacturer,2) reset gap from spark ...

vw gti 1.8t obd2 scan result 1. p0171 2. from vw service center p1136, p1570, p0571, p0562 Car is shaking a lot and when I press accelerator it is shaking much more, not only when I drive, but also it

VW B5 1 8T AWM Passat Bad Turbo make sure that that the pipe that leads to the blow of valve (bov) and make sure there is no hole that was my problem i replaced that after buying a new turbo because i

...VW Beetle, started having trouble accelerating between 30-40 miles per hour. Replaced spark plugs, plug wires, fuel filter, air filter and intake hose before putting in the shop. Mechanic stated #1, ...