2004 Mitsubishi Galant "change crankshaft position sensor 2005" Questions

Ad

Question about Mitsubishi Galant

1 Answer

change timing belt galant 04 mivec 2.4 Timing belt ?B? (balancer belt) and related components?2004?2005 Galant and 2004?2005 Lancer 2.4L engine Disconnect the negative battery cable. Remove the engine

Ad

...change crank sensor and clear code but the dash board kept coming back.. Error Code: P0335 Description: Crankshaft Position (CKP) Sensor - Circuit Malfunction Possible Cause: Wiring. Crankshaft ...

Ad

Question about Mitsubishi Galant

1 Answer

...electrical circuit first , video's on youtube , all you would need is a DVOM - digital volt ohm meter . P0335 Kia Crankshaft Position Sensor Circuit c Replacing Crankshaft Position Sensor Code ...

Question about Mitsubishi Galant

1 Answer

...sensor but still the problem is there, is there another problem what fault code do you have. If you changed the crankshaft sensor you also need to change the camshaft sensor, they go hand in

Question about Mitsubishi Galant

1 Answer

...crankshaft position sensor signal Cause: It is caused due to leaking from thermostat housing into crankshaft position sensor harness multi-plug Remedy: Check and clean the crankshaft position sensor ...

Question about Dodge Cars & Trucks

1 Answer

...sensor to module need verification . The crankshaft position sensor can go bad on Dodge engines and throw a camshaft position sensor code too . Try unplugging it with the in off position then try it

...crankshaft position sensor and How do I determine which cylinder is #1 and #7? I recently changed all coil 8 coil packs and 16 spark plugs. I have a code saying ignition coil A failure and the ...

Question about Mitsubishi Galant

2 Answers

...crankshaft. It detects the fluctuation of the engine rev-olution. The sensor consists of a permanent magnet and Hall IC. When the engine is running, the high and low parts of the teeth cause the gap ...

Question about Mitsubishi Galant

1 Answer

...crankshaft position sensor, but I changed it and it's still doing it. 2005??? dealer only encrypted software so a plug in scanner will read the wrong code .From description try changing the coil ...

...2005 chevy silverado 4.3L coil has been changed crankshaft position sensor changed and everything obvious changed Do you have power going to the coil, and a ground signal coming from the distributor

Not finding what you are looking for?
2004 Mitsubishi Galant Logo

443 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...