release bearing isnt riding on the pressure plate [would be the same as riding the clutch] the 1/2 inch higher than brake pedal probem can be adjusted on the pedal stop but shouldnt be the problem. of
...clutch,or the linkage.The release bearing will most often have a squeal or a hissing sound.The clutch fork can rattle, if the ball pivot retainer is broken.You may feel some unwanted slack in the ...
...when the defrost mode is turned on. Turn off all heater controls. If the noise is gone it will be either the Air conditioner compressor clutch bearing or possible the idler pulley bearing . The ...
release bearing you need to take the box out and replace it and the pressure plate will be also damaged due to the bearing seizing basicly the whole clutch assemablly will need replacing sorry cold be
...release the clutch the noise comes back. the clutch disc, pressure plate, release bearing, main drive bearing,and counter gear bearings has been replaced. In the morning WHEN THE ENGINE IS COLD YOU ...
...SUCH AS THE ALTERNATOR ,AIR CONDITIONER COMPRESSOR, CRANK SHAFT PULLEY OR HARMONIC BALANCE PULLEY,VALVE TAPPETS MAKE NOISE IF ENGINE OIL TOO THICK.FAULTY CLUTCH RELEASE BEARING MAKE RATTLING
Question about Mitsubishi Mighty Max
...bearing and clutch, noise is exactly the same trans rattles under load,made noise when clutch was released(in gear or not)installed full clutch kit,crank'der up! same noise,same exact problem bad ...
...release the clutch. I thought it was only with the clutch released but recently I discovered it does it with the clutch pressed in as well if I give it gas at the same time. But it does do it less ...
...clutch which is noisy whenever the pedal is pushed down may have a worn-out or unlubricated release bearing. Note that this isn't just a squeak from the pedal (just lubricate the pedal if it is!) but ...
210 questions posted
Usually answered in minutes!
85 Questions
77 Questions
75 Questions
62 Questions
46 Questions