1991 Mitsubishi Mighty Max "bleeding clutch stop slipping" Questions

...clutch you need to adjust it. if its hydralic then the master cylinder may be not bleeding off properly when cold or slave sticks when cold. you need to measure pedal free play that is how far pedal ...

...stop/starts the pedal loses all free play and clutch has tendency to slip in higher gears when engine power is appllied. Clutch pedal is also hard/tight against back stops after these stop/start ...

...stop if i take foot of brake and keep clutch depressed car still moves forward...could it be the master cylinder or is the clutch toast? i think that either your a very bad driver on a manual box or ...

...Slipping clutch, replace disc. Pressure plate I found a Repair Manual ...

...stop light where it seemed to be working better, and managed to drive it home with minimal slipping. This truck has a hydraulic clutch pedal. Could the clutch master cylider malfunction and not ...

...stop sign and sometimes gear grinding on 2nd and 3rd gear. It sounds like your clutch isn't releasing properly. Do you need to adjust the pedal free play or bleed the hydraulics? If that doesn't fix ...

...clutch pedal a few times and hold to floor and you open bleeder valve at slave cylinder till air is gone,just don't let resevoir get low.Here is a link to bleeding,your slave cylinder is bolted to ...

...clutch? Just an opinion, I don't know a lot about Saturns but I'd say your throwout bearing is starting to go bad. Bleeding won't help that,they have to be replaced. If there is any linkage between ...

...clutch release lever. Find the bleed screw on the bottom of it and fit the surgical tubing over the end of it. Fit the other end of the tubing over the end of the syringe. Carefully loosen the bleed ...

bleeding the slave cylinder on a 2000 jeep wrangler how do I do this? If your jeep is high enough without using jack stands, crawl under the vehicle, and on the left hand side of the clutch housing is