2001 Mitsubishi Mirage "dpfe sensor test p1400" Questions

DPFE sensor is usually not hard to change. There are 2 small rubber hoses that run from the EGR tube to it... Replace DPFE sensor, reset engine fault codes. The Ford one is a good one and rockauto.com

...DPFE sensor. Check this out. http://www.fordforums.com/f57/2002-ford-explorer-p1400-code-dpfe-sensor-150191/ Best Reguards, Premium FixYa Support Hi there: DTC P1400 - Differential Pressure Feedback ...

...LOW VOLTAGE detected. most likely is a problem with the wiring to the egr or dpfe sensor. the pinpoint tests for code p1400 instruct you to test all wiring before replaceing the egr or dpfe ...

dpfe sensor,its alot of times bad,first test egr valve with applied vacum to determine its not bad.tube running to exhaust can and does clog with carbon over years.if its clogged must be cleaned.check

...DPFE EGR Circuit Low Input". for a P1400 code . The sensor is located on the pass. side of the eng comp. back near the firewall. It sits on top of two small rubber hoses that attach to metal tubes. ...

...DPFE) sensor signal was below 0.2 volts. Enabling conditions: Run engine off or running self tests to check this code.Blocking Action: This code can block the following monitors: Fuel Control, O2 ...

...DPFE sensor low voltage. This is the feedback sensor for the egr valve and it has exhaust gases running through it at basically all times. They have 2 different styles (plastic and aluminum) and they ...

...sensor cleaned the carbon build up fixed and $400 later computer says P1400. I need to get this fixed so it can a pass the safety inspection. How much does it cost to fix it and where is this part ...

...DPFE) sensor voltage. The voltage in this sensor changes as it detects a difference in vacuum. Test: Engine running, so be careful and use proper care! Find the EGR valve and disconnect the vacuum ...