2001 Mitsubishi Galant "lock key" Questions

Ad

Question about Mitsubishi Galant

2 Answers

...lock will prevent the key from turning. Sincerely, JC In my Galant the problem was that the key was really worn down and it didn't have any ridges that would engage the spindles inside the lock ...

Ad

...key pin cuts (don't make it any longer than this; you don't want to grind pasteboard into the lock mechanism). Slide it into the lock several times to clean off any gunk that might have been ...

Ad

Question about Mitsubishi Galant

1 Answer

...key to the lock and a 1/8" flat blade screw driver. Notice that your lock only turns 1/4 rotation, after doing this procedure you will be able to turn the lock an extra 1/4 turn counter clock-wise ...

Question about Mitsubishi Galant

1 Answer

...key lock. try to remember whihc way the wheel was turned when parking. pull down real hard in same direction and turn key. sometimes you have the pull on wheel very hard in either direction while ...

key to release the lock.  It may be related to the RF in my key and it just stopped allowing the trunk to be opened.  It would not open from the driver's seat release either.  I saw

Question about Mitsubishi Galant

2 Answers

Key is stuck in ignition and does not go into lock. It stops in ACC. you will need new ignition lock the part in the lock is worn out if you take it out it my not start than keep the key in car until ...

Question about Mitsubishi Galant

1 Answer

...key or driver master lock (all doors) is used inside. hi there is a motor placed inside the doors for the operation of the central lockin system. when you open the door by key this motos is activated ...

...the power lock inside the car, but can be locked use the key. All other three door locks are good for both remote control and inside lock needs a new door lock actuator usally built into the door ...

Question about Mitsubishi Galant

1 Answer

...of iginiton turn key to off/lock position. then turn steering wheel left/right at the same time pulling out key. lubricate key hole with wd40. there is button over or under the ignition key assy. ...

Question about Mitsubishi Galant

2 Answers

...key goes into the cylinder or you can create damage to the other mechanisms and get into costly repairs. If you drill no deeper than 1 1/4 inch or so, you will still be within the cylinder. You can ...

Not finding what you are looking for?
2001 Mitsubishi Galant Logo

1,076 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...