Question about Mitsubishi Galant
no heat after flushing heater core individually, changing radiator, thermostat, burping, no leaks? only some heat after revving engine past 3000 rpms and trying to over heat. It will take some time to
Question about Mitsubishi Galant
changed out radiator, thermostat, flushed, burped, no leaks, still no heat unless car is revved up beyond 300 rpms and trying to over heat Could be the water pump. Impellers do spin on the shaft. ...
your thermostat will be right there always be sure to use a new gasket top off your antifreeze and burp the system for air bubbles and top off again if necessary
...is a common problem on this car.they where all made of plastic gear. goodluck!! ed I found I had to burp the coolant system on my 2001 Montero. Wait til its cool, remove the radiator cap, remove the ...
Replaced upper Radiator Hose and refilled overflow tank, do you have to burp the radiator or will it start circulating on its own! I got a kick out of asking if you have to "burp" the ...
Question about Chrysler Cars & Trucks
What does the term burp refer to when installing a rebuilt engine and new air intake manifold on Chrysler 300C 5.7 hemi? Blew a valve seat in old engine and destroyed the engine and intake manifold. ...
bleeding cooling system overheating after thermostat changed sounds like air in system ... Leave the radiator cap off, turn the engine on and let it run until the radiator "burps": You will see the ...
nedd to burp cooling system burp cooling system Duplicate question.
Just replace radiator on my 97 isuzu rodeo v6 and is not overheating do i have to burp it anyway? Burping it is much easier than replacing the motor if you're wrong.
Heater works at idle , very little heat while driving air trapped in system, very common. need to burp it. go to shop with evac/fill equipment so they can burp and chage antifreeze at same time. go ...
1,076 questions posted
Usually answered in minutes!
851 Questions
799 Questions
747 Questions
325 Questions
312 Questions