2002 Mazda Tribute "hold function thermostat" Questions

...told me everything checked out ok but told me to replace thermostat. These cars are terrible for holding air pockets once the cooling system has been drained. Run the heater on max and let the car ...

...low speed fan function, temp sensor for high sppeed aux fan funtion, thermostat, water pump, radiator cools 15 dgrees from inlet to outlet. Check all that and youll find something wrong I am

...hold steady, replace the fuel filter.Additional Checks: Make certain that the engine thermostat is functioning and is the correct temperature. Make certain that the alternator voltage output is not ...

...remove and test the thermostat:
1. Turn off the engine and allow to cool.
2. Remove the bolts holding the thermostat cap.
3. Lift off the housing cap to expose the thermostat. 4. Pull the ...

function of everything mechanical absolutely find it critical the a precise operating temp be maintained, hence the open and close operation of the thermostat. It’s time to start checking other things

function that way. If your car has a thermostat gasket, you will need to replace that as well. If it has machined surfaces in lieu of a gasket, you will need to throughly clean and dry both surfaces,

...thermostat and the coolant temperature sensor located? Also, when the condenser fan blew out it got stuck inside and and came off from one of the holding screws and damaged the radiator and it has a ...

...thermostat will not function correctly once it is contacted by oil. If oil is found in the cooling system, it must be flushed and the thermostat's cartridge replaced. 8. Inspect the thermostat ...

...temperature. when you changed the radiator, was the rad cap also changed? if the cap is not holding correct pressure, it will lower the boiling temp of the coolant and cause it to overheat.

hold gas petal down to the floor. Whats going on with my car its like its stalling Rad hose issue. Did u put the new thermostat in right? Did you install the right temp stat? Is ur water pump working.