...chevy suburban runs rough with no engine lights it has a 350 i just had the intake manifold gasket done spray carburetor cleaner to the surrounding gaskets of the intake manifold while the engine is ...
how to perform intake manifold vacuum test on chevy suburban 2003 use a dyson vacuum
...chevy suburban runs bad has new fuel pump, fuel filter,plugs wires cap rotor fuel regulator coolant temp sensor cleaned maf reman engine with 40k on it Check if the spiders are bad... I May be off a ...
...intake manifold gasket, injectors, fuel relay, O2 sensors, catalytic convertors and air filter. Please help! Hello, Have a look at your Crankshaft and Camshaft sensors. As I remember there was a ...
...Chevy suburban 1500 that stalls when driving.When taking off from a stop it stalls. I had the fuel pump changed about 2 1/2 years ago.The manifold intake gasket and timing chain about 3 weeks ago and ...
...Chevy K1500 5.7 Suburban that has hesitation and lack of power issues. It studders when I press on the gas pedal and most times has a delay in acceleration. In idle the RPM's seem to go up and down ...
...intake manifold. Back off the rocker arm adjusting nuts and remove the pushrods. Keep them in order for installation. Remove the lifter retainer bolts, retainer and restrictor. Remove the lifters. If ...
Question about Cars & Trucks
...Chevy S10 2.2 from the top of the Intake Manifold ...
...chevy v-6 4.3 torque sequence and settings for intake manifold lower intake manifold step 1 27 inch lbs. step 2 106 inch lbs. step 3 134 inch lbs. upper intake manifold step 1 44 inch lbs. step 2 80 ...
Question about Chevrolet Suburban 1500
...intake manifold bolts for a 2002 Chevy Malibu with a 3.1L need to be torqued to? Pretend the picture is lower intake manifold, that is the tightening sequence. 1st step 5 ft lbs 2nd step bolts 1--4 ...
1,294 questions posted
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions