2000 Buick Century "wiper arm" Questions

my winshield wipers are stuck up ward instead of down what so I need to repair this the wipers till work but they will not park in the down position, correct? The usual fix for this is to replace the ...

...wiper arm assembly which would be over $700 to replace. I decided to have a look myself and discovered that a small metal tab which makes the wipers park was bent and the mechanism was not engaging ...

If I remember correctly if you lift the wiper arm and push this clip in it will hold the wiper up and also release it from the transmission. You will have to wiggle the arm to get loose. Good luck....

...SLAPING THE DOOR SIDE MIRROW ON A 2000 BUICK CENTURY. THE NUT ON THE WIPER ARM IS TIGHT AS IT WILL GO. take the wiper arm off, look at the spline for the arm and the car and see if either is ...

...wiper arm, then remove plastic cowling, the remove plastic cover over motor, then u will see tab bend it back up and u will be fixed. mark wiper arm position on shaft so you assemble in the same ...

arm on these wiper motors is not solid.....they rotate on themselves......as they rotate around, there is a moveable "peg" underneath the arm.....when you shut the wipers off, this peg catches a "tab"

...wiper arm bolt needs to be tighened, or more common the arm needs to be replaced. where the bolt is the end arm insert is made of soft led as to strip out if arm becomes binded by snow, tree branch ...

wiper arm/blade is disconnected. (The wiper motor is about the size of your fist, and has a few wires attached to it.) Probably a plastic bushing has fallen apart on the connecting link. You will need

...wiper arm on drivers side is off track ,how do i fix it? Let the wiper work with the blades pulled out of the glass. Now switch off and allow it to park. You can now see the difference in the lefft ...

...wiper arm, under it you will find a nut. check to see the nut is tight. turn the wipers on and observe the post that the nut is on, if it is turning, then the nut needs to be tightened or the spline ...