2005 Nissan Murano "o2 sensor" Questions

...o2 sensor from the header back. you will need a o2 sensor socket.you can cheat and use a 7/8 open end wrench.my best advice is to set the car up. by warming up the car.just warm it up dont get it ...

...o2 sensor.(sometimes fitted onto the front of the cat.depending on market(im in England) you only need to remove this sensor and replace it with a new one.(you can do this yourself,its easy.) for any ...

O2 sensors. Check for vacuum leaks and make sure the hoses are hooked and tight from the air filter box to the throttle body. P0725 is engine speed sensor/ input shaft speed sensor on the transmission

...O2 sensors found in my engine bay have already been replaced so I kind of narrowed it down to the remaining 2). As the catalytic is brand new and there are no exhaust leaks, I am forced to conclude ...

...performance with the least amount of fuel. If the oxy sensor malfunctions you'll get the incorrect fuel/air mix and waste fuel. Some vehicles see a 10% increase in fuel use with a bad O2

...o2 sensor is the fact that the wires have been damaged and that there is a dead short to ground. Probably the wires are severely twisted and a wire has broken and touching the earth wire or the metal ...

...o2 sensor is heated, and needs replacing. How do i do the replacement? It is the front sensor that needs to be replaced. local auto zone or advance has a tool for rent,special socket for ...

...where can I find them There are two of them, one is on the exhaust manifold under the hood and the other is after the catalytic converter. 2009 2012 Nissan Murano Air Fuel Ratio and O2 Sensor ...

...the O2 sensor heater banks. question edited for clarity, maker is Nissan. Question moved to Model Category. https://www.google.com/search?q=2009+Nissan+Murano.+Wiring+diagram+O2+sensor+heater+banks

WHAT IS P1148 CLOSED LOOP-B1 and P1031 A/F SENI P1148 CLOSED LOOP-B1 and P1031 A/F loosen and re tighten the top left (rear) o2 sensor and check the connector is not loose...