1998 BMW 5 Series "ac actuator cost" Questions

...actuator cable, or faulty DCS/ASC control unit. If you know how, you can disconnect the speed sensors, and check for voltage output across the the terminals inside the connector going to the speed ...

...ac is blowing hot on one side and cold on the other. it is a 2004 chevy avalanche. i was told it is the actuator for both sides. how hard are those to replace and what actuators are they that i need ...

...ac actuator you can find the videos, I belive one guy was named Froggy. My passenger is stuck on cold and the driver side makes noise when moving to cold, the driver side also seems to hesitate going ...

...AC and barely plug in the actuator until is moves to the position so that it lines up with the blend door. When lined up the actuator should fit right back in place. You could also compare the old ...

...ac works just sometimes after being recharged from authorized personell....wasnt really working before either...not sure if makes a differance..its a european model because im here in germany and not ...

...actuator motors that opens and closes the airflow doors withing the AC/heater ducting, more than likely the door is sticking and this causes the motor gear drive to slip as the tiny Nylon gears slip ...

AC settings. It used to be intermittent but now it's all the time and louder. Thoughts? The actuator costs about $65.00. there is a motor for mode change located there needs to be changed Just had the

actuator is working fine. The most common cause for hot air coming through the vents with the AC on is the system is most likely low on refrigerant. There are leak detector kits available at most auto

...same thing on a 2014 it is on pass side would be right above your feet on right advance dont carry them but autozone does i believe around 25 bucks half of dealer cost Its the ac/heat actuator door ...

...actuator has malfunctioned. This can happen if the battery is replaced or dies and the AC is not turned off. Sometimes removing the fuse for the AC and allowing the actuators to recalibrate works but ...