1993 BMW 3 Series "clear bare wire" Questions

...just need a good tune up.....Disconnect battery before changing coils,wires..,or plugs in order to clear the fault

...BARE SPOTS, BUT ALL YOU HAVE TO DO IS STRIP THE HARD PLASTIC AROUND THE WIRES BACK ENOUGH TILL YOU SEE GOOD CLEAN LOOKING WIRE,THEN SEPERATE THE WIRES AND IF YOU HAVE LIQUID ELECTICAL TAPE USE THAT ...

...bare ends on the ground connection and other end on a clear spot on the bumper and have someone push the button to turn on the wiper. A good spot would be where the wiper comes thru the door to hold ...

...or clean thoroughly. Then clear the connection point on the frame to bare metal and reconnectwith new hardware. Be surre and use something like anti-sieze (best) or grease at this

...wire barely away from module , while someone tries to start engine in short bursts. Try not to make contact with vehicle besides this hand and keep clear of moving engine parts. Best to use rubber ...

...clear all the codes after you changed the camshaft position sensor? Also what kind of car are you working on? And where was the sensor located on the engine? I’ve had wires that were shorted out that ...

...yes you have a short look at the positive cable make sure it is hooked up right and there are no bare spots in it and check the red wire on the back of the alternator make sure it is clear of all ...

bare wire and messed up abs module itself? How can i check or repair module myself?? Ive cleared the code and it comes right back. My abs and traction control lights are on also but only came on after

Washer works okay on drivers side but is barely flowing on passenger side. Try to take a SMALL WIRE and clean it out, or take the hose off, and try to clear it with compreesed air.

clear my back window. The light comes on when the button is pushed on the dash but nothing seems to happen. What could the problem be and where to look. Not the fuse. check the wiring harness near the