1992 BMW 3 Series "torque sequence timing chain cover" Questions

...sequence until you get the desired torque. i need the torque seeting for the camshafts on a bmw328i e36 fuel squirting into manifold while ignitions off could it be a faulty fuel pump or relay its ...

torque setting. If so here is BMW 6 cylinder engine According to my manual as follows: cyl head to engine block stage 1 30nm(22ft-lb) stage 2 + 90 degrees stage 3 + 90 degrees cyl head to lower timing

...Torque lefthand valve cover bolts in sequence, as illustrated in Fig. 9, to 106 inch lbs. k. Torque righthand valve cover bolts in sequence, as illustrated in Fig. 10, to 106 inch lbs. l. Torque ...

...torque sequence Cylinder head and discard the gasket WARNING With the camshafts remaining in the cylinder head some valves will be open at all times. Do not rest the cylinder head on a flat service ...

...torque sequence - 3.5L (VIN H) engine Install the cylinder head with a new gasket. Install new M11 bolts and M6 bolts. Torque the M11 bolts in sequence to: Step 1: 30 ft. lbs. (40 Nm). Step 2: 100 ...

...cover bolt torque sequence and specification-3.8L Engine Install the timing case cover oil seal. Continue the installation in the reverse order of the removal procedure. I hope that this image

...sequence. I'll ad the torque spec. at the end but this is where if you tighten out of order something will break. pump assembly to timing chain housing nuts. pump cover to pump body bolts pump cover ...

torque sequence-4.6L engine Install the cylinder head with a new gasket. Lubricate the bolts with engine oil prior to installation. Torque the M11 bolts in sequence as follows: Step 1: 30 ft. lbs. (40

...Torque the head bolts in the sequence shown in the illustration, utilizing the following steps and tightening values: Step 1: bolts 1 through 8: 35 ft. lbs. (48 Nm). Step 2: bolts 1 through 8: 55 ft. ...

...torque in sequence as follows:Pump assembly to chain housing nuts and torque to 26 Nm (19 lbs. in.) Pump cover to pump assembly and torque 14 Nm (124 lbs. in.) . Cover to block, bottom bolt first and ...