2006 Pontiac Torrent "replace latch control" Questions

...12 volts. Install a jumper wire between the ground terminal 2 and ground. Verify the actuator turns on & off. ?‡' If the function does not perform as specified, replace the applicable door

...replace this latch? Any diagrams, advice or practical suggestions are SINCERELY welcomed. Removal Disconnect battery ground cable (14301). Remove front door trim panel (23942) and watershield from ...

...latch control cylinder rod (22134) from the door lock cylinder (21985). Remove front door latch remote control and link (21818). Remove the front door latch retaining screws. Disconnect the door open ...

...replace it? Is there a button somewhere or manual lever? There is NO key hole. The liftgate consists of the following components: liftgate door lock actuator liftgate lock cylinder (if equipped) ...

...latch relay coil control circuit to the endgate latch relay. This output is used to energize the endgate latch relay when an endgate swing latch or drop latch request has been made. If the endgate ...

replace the latch assemby on the rear liftgate on my 2002 Explorer I have this problem. The handle just dangles loosely from its hinges and performs no function. The pin that connected it to the latch

...control rods and remove the fasteners for the latch. Reverse procedure to install. Before going out and replacing it, spray the latch with wd40 or other solvent just to make sure it isn't internally ...

...that it it latched in place. You will need to replace the power liftgate latch assembly. Let me know,if needed further assistance. Hope i helped you. Thanks for using ' Fixya ' and have a nice

...replace the cable. The latch has 2 positions halfway and full way when closed. To have a peace of mind, have it halfway latched then tie a string from the hood latch to the grill for temporary until ...

...replace them if necessary. Damaged Latch or Actuator: The latch or actuator that holds the door in place may be damaged or malfunctioning, preventing the door from closing properly. Inspect the latch ...