why 05 duramax cranks but want start Ran fine no problems day before. Next day will not start but cranks fine. Bleed and primed filter and is holding pressure SEE IF THE GLOW PLUGS ARE WORKING
my 05 gmc sierra 1500 t4x4 transmission,do not work,i press the 4x4 button blinks but dont shift? Most likely it is just the 4x4 switch that isn't working Replaced mine in my 2000 blazer for 60bucks. ...
...05 duramax cranks but want start Ran fine no problems, next day cranks but won't start. Bleed and primed and holding pressure on filter. Hey im not 100% sure this is it but it sound like it.. I had ...
05 Sierra 4x4 wont shift into OD until it has warmed up for a while, this only happens when there are sub freezing temps, is this a problem, and if so what should i do?? This is normal on newer ...
...05 duramax start Cranks but will not start at all. Have bleed and primed fuel filter and Is holding pressure. Are any light's lite on dash ? check engine ? There are a lot of electronic components on ...
Question about GMC Sierra
...it starts to skip a little. you can try to clean out the 02 sensors I had a problem like this in a 05 saturn. The 02 sensor that I cleaned was located towards the front of the engine behind the fan ...
...05 gmc sierra. It has always ran at about 190 - 195, i noticed today that when i started the truck (already warmed up) the temp went to 190. Then after about a minute or so, it drops to the bottom ...
problems are present. Freezing temps? you may need the power steering pump pressure checked, a weak pump may do that???. Be sure it has the correct fluid , tire pressures to spec? could just be normal
starts, won't idle, stalls My daughter had the same problem with her 05 Trailblazer . The gas for her air was low . Topped it up and truck ran great .
721 questions posted
Usually answered in minutes!
987 Questions
847 Questions
676 Questions
601 Questions
604 Questions