...supply lines is shorted to ground. REMEMBER. Fuses gets blown when its supply line is shorted to ground. If fuse does not blow, connect each component one at a time. The component that blows the fuse ...
Question about Cars & Trucks
...to radio. Replace backup fuse and check if drain still happens. If so, your radio may have internal power short and needs to be replaced.If not, shorts maybe along the the supply lines after the
Question about Oldsmobile Regency
...supply shows (set to 5amps) shows 5amps. its short, with one eye on that dial i pull all connectors on the brake feed line bam this connector cut current to zero so the short of to rear. i pull more, ...
Question about Toyota Cars & Trucks
...of wire designed to fail in the event of a short circuit though age and vibration also has an effect on them. Two or more are often found in the various supply lines and sited close to the
...short high pressure line between the pump and outgoing fuel supply line doesn't have any cracks (the small line inside the tank) -- I had same symptoms only to find pump could not hold pressure ...
...supply line to MAP sensor Engine vacuum leak Short on signal wire to PCM Short on reference voltage wire from PCM Open in ground circuit to MAP Worn engine causing low vacuum Bad MAP sensor Leak in ...
...short time. I changed the fuel filter, continues stalling. P0107 map sensor circuit low- the map sensor sends signal to computer for control of fuel injection, it's on firewall side of engine, above ...
...short then i try each door manually , 1 by one form the local door switch lock to see if one door blows the fuse when activated. BINGO, so then unplug that door lock solenoid, still blow the fuse (i ...
Question about Oldsmobile Regency
short to ground in the supply circuit. Work from the bulb socket backwards to the fuse. Check between the hot supply line to ground there should be not circuit when the fuse is out. If you find one at
...Supply Line Replacement Am trying to remove this line to replace it with a new one since the rubber line came out of the metal sleeve. I need to remove it where the line joins with the fuel rail. I ...
134 questions posted
Usually answered in minutes!
60 Questions
146 Questions
103 Questions
72 Questions
64 Questions