2002 Nissan Xterra "rpm needle move starting engine" Questions

...rpm needle was going up & down then when i tried to go it hesitated - like it wasn't taking gas or something. it would kind of lurch & then pull back with the rpm needle going up & down ...

...needle on the rpm gauge moves up and down. Then when put in park the rpm rev up to 2 and it won't come down? What type of car???? could be something in the computer/engine control system. if its a ...

needle move with 3000 rpm high then normal. remove the cluster and remove the glass. connect the cluster and turn ignition ON. remove the needle and correct the position to 0 rpm. Start the engine and

...RPM at about 1500 . As the needle on the gauge moves to the center or a little bit higher , the cooling fans should start up . If the needle continues to climb towards the red zone but the fans don't ...

...needle for the RPM jumped back and forth for a few seconds, then went to zero. After pulling away from the drive and up to the 1st stop sign, the needle finally started to move between 1 and 2. Is ...

...needle moves back and forth while driving it checked oil its good now its clicking underneath the car and it felt like the transmission was slipping could it be the oil pump going bad? First we would ...

...rpm needle moves a lil when you crank. the problem could be the coil pack too its on the top of the engine by the fire wall. need more details. does it has gas coming to the engine. injectors have ...

to the floor but car is barely moving. It does eventually pick up speed, then same issue at the next red light. My RPM needle is jumping when I accelerate. Take to dealer,warranty will fix it for free

...it ran good for 15 min then back to no start, there should be something shorting out the crank sensor. are you getting rpms in live data or do you see if the rpm needle moves when you crank the ...

...needle moving a little? If not, as mine didn't, I believe you want to check into the RPM sensor. Check the RPM sensor located on the back of your engine, connected to the bell housing. The wire runs ...